06-2011, rev. 0611 www.te.com ? 2011 tyco electronics corporation, a te connectivity ltd. company. datasheets and product specifcation ac - cording to iec 61810-1 and to be used only together with the defnitions section. datasheets and product data is subject to the terms of the disclaimer and all chapters of the defnitions section, available at http://relays.te.com/definitions datasheets, product data, defnitions sec - tion, application notes and all specifcations are subject to change. 1 power relay k (open C sealed) automotive relays pcb single relays n limiting continuous current 45a n wide voltage range n 24vdc coil versions available n for high current version refer to power relay k-s typical applications abs control, blower fans, car alarm, cooling fan, engine control, fuel pump, hazard warning signal, heated front screen, heated rear screen, ignition, lamps front/rear/fog light, interior lights, main switch/supply relay, seat control, seatbelt pretensioner, sun roof, turn signal, valves, window lifter, wiper control. contact data typical applications resistive/inductive resistive/inductive indicator lamps headlights, headlights loads loads capacitive loads capacitive loads contact arrangement 1 form a, 1 no 1 form c, 1 co 1 form a, 1 no 1 form a, 1 no 1 form c, 1 co rated voltage 12vdc 12vdc 12vdc 12vdc 12vdc a/b (no/nc) a/b (no/nc) rated current 45a 45/30a 30a 40a 40/25a limiting continuous current 23c 45a 45/30a 30a 40a 40/25a 85c 30a 30/25a 25a 25a 25/20a limiting making current 1) 100a 100/30a 120a 3) 180a 180/60a limiting breaking current 2) 60a 60/30a 60a 60a 60/30a contact material agni0.15 agni0.15 agsno 2 agsno 2 agsno 2 min. recommended contact load 1a at 5vdc 4) initial voltage drop, at 10a, typ./max. 20/300mv operate/release time typ. 5/3ms 5) electrical endurance >2x10 5 ops. >2x10 5 ops. >2.2x10 6 ops. >10 5 ops. >10 5 ops. at 13.5vdc, 40a at 13.5vdc, 40a up to 8x21w up to 4x60w up to 4x60w mechanical endurance, dc coil >10 7 ops. 1) the values apply to a resistive or inductive load with suitable spark suppression and at maximum 13.5vdc for 12vdc or 27vdc for 24vdc load voltages. 2) for a load current duration of maximum 3s for a make/break ratio of 1:10. 3) corresponds to a peak inrush current on initial actuation (cold flament). 4) see chapter diagnostics of relays in our application notes or consult the internet at http://relays.te.com/appnotes/ 5) for unsuppressed relay coil. a low resistive suppression device in parallel to the relay coil increases the release time and reduces the lifetime caused by increased erosion and/or higher risk of contact tack welding. te0556-e max. dc load breaking capacity load limit curve 1: arc extinguishes, during transit time (changeover contact). load limit curve 2: safe shutdown, no stationary arc (make contact). load limit curves measured with low inductive resistors verifed for 1000 switching events.
06-2011, rev. 0611 www.te.com ? 2011 tyco electronics corporation, a te connectivity ltd. company. datasheets and product specifcation ac - cording to iec 61810-1 and to be used only together with the defnitions section. datasheets and product data is subject to the terms of the disclaimer and all chapters of the defnitions section, available at http://relays.te.com/definitions datasheets, product data, defnitions sec - tion, application notes and all specifcations are subject to change. 2 automotive relays pcb single relays power relay k (open C sealed) (continued) insulation data initial dielectric strength between open contacts 500vac rms between contact and coil 500vac rms other data eu rohs/elv compliance compliant ambient temperature, dc coil -40 to +105c 6) climatic cycling with condensation, en iso 6988 3 cycles, storage 8/16h temperature cycling (shock), iec 60068-2-14, na 20 cycles, -40/+85c (dwell time 1h) damp heat cyclic, iec 60068-2-30, db, variant 1 6 cycles, upper air temperature 55c damp heat constant, iec 60068-2-3, method ca 56 days, upper air temperature 55c degree of protection, iec 61810 rt 0/ii C open version rt iii C immersion cleanable version corrosive gas, iec 60068-2-42 10 days iec 60068-2-43 10 days vibration resistance (functional), iec 60068-2-6 (sine pulse form), acceleration, acc. to position 10 to 200hz, 20 to 40g 7) shock resistance (functional), iec 60068-2-27 (half sine form single pulses), acceleration, acc. to position 8ms 30g 7) terminal type pcb weight sealed version approx. 22g (0.77oz) open version approx. 19g (0.67oz) solderability (aging 3: 4h/155c) for leaded process (tm = 183c), for pb-free process (tm = 217c), iec 60068-2-20 ta, method 1, hot dip 5s, 215c storage conditions according iec 600688 8) packaging unit sealed version 300 pcs. open version 500 pcs. 6) see coil operating range dc. 7) no change in the switching state >10s. 8) for general storage and processing recommendations please refer to our application notes and especially to storage in the defnitions or at http://relays.te.com/appnotes/ coil data rated coil voltage 12vdc / 24vdc coil versions, dc coil coil rated operate release coil rated coil code voltage voltage voltage resistance power vdc vdc vdc ?10% w 001 12 6.9 1.2 90 1.6 022 24 14.1 2.4 362 1.6 all fgures are given for coil without pre-energization, at ambient temperature +23c. other coils on request. coil operating range does not take into account the temperature rise due to the contact current e = pre-energization te0555-6 does not take into account the temperature rise due to the contact current e = pre-energization 1 form a, 1 no te1086-a1 te1091-b1 1 form c, 1 co terminal assignment (open and sealed version) bottom view on solder pins *) terminal 4 to be bridged
06-2011, rev. 0611 www.te.com ? 2011 tyco electronics corporation, a te connectivity ltd. company. datasheets and product specifcation ac - cording to iec 61810-1 and to be used only together with the defnitions section. datasheets and product data is subject to the terms of the disclaimer and all chapters of the defnitions section, available at http://relays.te.com/definitions datasheets, product data, defnitions sec - tion, application notes and all specifcations are subject to change. 3 automotive relays pcb single relays power relay k (open C sealed) (continued) ? 2.3 +0.1 ? 2.3 +0.1 ? 2.3 +0.1 2.3 0.2 13.3 0.2 2.2 0.1 3.3 0.1 12.1 0.1 5.4 2.4 1.3 +0.1 6.0 0.2 10.2 0.2 16.0 0.3 1.0 +0.05 1.0 +0.05 ? 2.1 +0.1 te0575-k2 terminals tinne d assembly an d positioning ai d additional tin top s max. 1.5 mm 3.0 0.5 *) 3.4 0.1 3.4 0.1 *) 8.5 0.2 26.1 0.4 21.1 0.4 21.2 0.3 0.55 0.25 2.5 ? 3.0 te0579-i2 ? 2.3 +0.1 ? 2.3 +0.1 ? 2.1 +0.1 ? 2.3 +0. 1 2.3 0.2 13.3 0.2 2.2 0.1 3.3 0.1 12.1 0.1 6.6 0.3 3.4 0.6 ? 1.3 +0.1 6.0 0.2 10.2 0.2 16.0 0.3 te0580-l2 terminals tinne d additional tin top s max. 1.5 mm *) 3.0 0.5 *) 2.5 ? 3.0 2.5 0.4 9.2 0.4 23.3 0.7 18.9 0.3 18.0 0.5 2.4 0.8 18.6 0.65 te2179-42 mounting hole layout bottom view on solder pins power relay k open version dimensions power relay k open version power relay k sealed version power relay k sealed version
06-2011, rev. 0611 www.te.com ? 2011 tyco electronics corporation, a te connectivity ltd. company. datasheets and product specifcation ac - cording to iec 61810-1 and to be used only together with the defnitions section. datasheets and product data is subject to the terms of the disclaimer and all chapters of the defnitions section, available at http://relays.te.com/definitions datasheets, product data, defnitions sec - tion, application notes and all specifcations are subject to change. 4 automotive relays pcb single relays power relay k (open C sealed) (continued) product code structure typical product code v23076 -a 1 022 -c 13 3 type v23076 power relay k, sealed v23133 power relay k, open terminal a pcb design 1 single relay 3 single relay coil 001 12vdc 022 24vdc contact type c single contact d single contact contact material 13 agni0.15 14 agsno 2 15 agsno 2 (special) contact arrangement 2 1 form a, 1 no 3 1 form c, 1 co product code terminal/encl. design coil contact cont. material arrangement part number v23076-a1001-c133 pcb, sealed single relay 12vdc single agni0.15 1 form c, co 1393277-4 v23076-a1001-d143 agsno 2 1393277-6 v23076-a3001-c132 agni0.15 1 form a, no 1-1393277-4 v23076-a3001-d142 agsno 2 1-1393277-7 v23076-a3001-d152 1) agsno 2 special 1-1414175-0 v23076-a1022-c133 24vdc agni0.15 1 form c, co 1393277-8 v23076-a1022-d143 agsno 2 1393277-9 v23076-a3022-c132 agni0.15 1 form a, no 1-1393277-8 v23076-a3022-d142 agsno 2 1-1393277-9 v23133-a1001-c133 pcb, open 12vdc agni0.15 1 form c, co 1393278-7 v23133-a1001-d143 agsno 2 1-1393278-3 v23133-a3001-c132 agni0.15 1 form a, no 5-1393278-7 v23133-a3001-d142 agsno 2 5-1393278-9 v23133-a3001-d152 1) agsno 2 special 1-1414173-0 v23133-a1022-c133 24vdc agni0.15 1 form c, co 3-1393278-7 v23133-a1022-d143 agsno 2 3-1393278-9 v23133-a3022-c132 agni0.15 1 form a, no 7-1393278-1 v23133-a3022-d142 agsno 2 7-1393278-2 v23133-a3022-d152 1) agsno 2 special 1-1414174-0 1) for indicator lamps.
|
